![]() For example the welder has a higher duty cycle, quick "euro" style disconnect torch, longer gun/torch with common consumables, HD cast aluminum feed/drive system with geared idler and drive rolls, cable wrap and upgraded despoiler with larger cabinet and easier spool access. The Forney 140 MIG is a complete change from previous Forney MIG welders and offers several upgrades. This is a multi-step transformer based machine. Welding processes are MIG (GMAW) and Flux Cored (FCAW). This machine is MIG ready with regulator and gas hose. I'm impressed with the overall quality and usefulness.ฤก40 Amp 120-Volt MIG Welder The Forney 309 MIG Welder, 120-Volt with The Forney 309 MIG Welder, 120-Volt with 140 Amp maximum output is an ideal machine for farms, automotive, and small repair welding using 115-Volt, household current. This nice little welder will be on hand to help with a host of other projects. It looks nice, is strong, and we saved ourselves thousands of dollars in the process. Splatter and slag buildup were tolerable, and about what you'd expect from a non-gas welder. Did something change in the design perhaps, or is the unit we bought just a bit more finicky? Not sure, but we adapted to the idiosyncrasies quickly. I didn't expect this, as another welder (same model) we rented did not have this problem. We tried re-trimming the wire end, twisting it, and shaking the end lightly, but to no avail. This takes about 5 minutes, which is a drag. Then the cable could be reconnected and the wire fed the rest of the way using the feeder. The cable had to be disconnected and the wire manually threaded into the hole in the tube. The wire would not always start into the hole in the feed cable. When the wire ran out, feeding a new spool was bit of a learning experience. Once we got the feeder adjusted correctly, the project went smoothly. ![]() We found it easy to over-tighten the feed roller, thereby smashing the wire and stopping the feed. ![]() Setting up was easy, and the pictorial and graphic set-up aids on the welder were quite useful in selecting heat settings and feed rates. Our materials ranged from 3/8-inch cold rolled round to 1/8-inch thick x 2-inch tube to 1/4 x 2-inch hot rolled bar. We each spent several hours using this welder. Both my brother and I had previous welding experience. My family bought this welder for use in building railings for a deck. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |